Thursday, 2 November 2017

Card number 3 in my christmas card series

Hi everyone I started my card by using a stencil which was tree/bark effect, I stuck my stencil over a piece of water colour cardstock, I then used my vintage photo distress oxide ink and a sponge applicator and gently went over my stencil until I had the desired effect. Next I stamped the polar bear image using memento tuxedo black ink. I used that ink as I was going to colour them using my spectrum noir alcohol markers. I used GB 1 & 2, DR1, FL3 and my blender pen. I fussy cut the image. Next I used my peacock feathers and salty ocean distress inks and blended them over the stencil image. I then used foam pads to adhere my images to the stenciled image. I then used a small amount of white acrylic paint and spritzed thid with water, I used my fan brush to flick the white paint over my card, this was to give a snowy effect. I stamped my sentiment and heat embossed over it using clear embossing powder. I used an a6 white card blank and matted it with a piece of red card, I then stuck my finished image on to my red card. I stuck my sentiment on to the card. I then went over the polar bears and my sentiment with my crafters companion sparkle pen and my card was finished
WATCH MY YOU TUBE TUTORIAL



Post a Comment